New tip request
#2
I was just about to mention the same thing. I just realized that for some 3d prints I'd need heat-set inserts, and that only soldering stations that I otherwise would not want to buy have support for the needed tips. It's good to know that using a cone tip is doable though.

I just noticed that the product page for the hammerhead tip is gone. I wonder if that's simply because of poor sales on it or if it's that they ran into trouble making custom tips.
  Reply


Messages In This Thread
New tip request - by acwest - 02-14-2022, 10:33 AM
RE: New tip request - by JoL - 03-17-2022, 02:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)