11-21-2023, 01:00 AM
Hey, newbie solder here
i bought a pinecil used it once and it was great
i whipped it out a few months later, today, to use it again and it reads low DC on the same setup as before
i tried to switch the power source but now it wont even power up? even on the setup that read low DC
tried different cubes, and cables even the barrel jack with blocks within the voltage range
i think it smells burnt or maybe it smells like a soldering iron. What gives?
i bought a pinecil used it once and it was great
i whipped it out a few months later, today, to use it again and it reads low DC on the same setup as before
i tried to switch the power source but now it wont even power up? even on the setup that read low DC
tried different cubes, and cables even the barrel jack with blocks within the voltage range
i think it smells burnt or maybe it smells like a soldering iron. What gives?