PCIE SATA controller ASM1062 problems or software

[Nikolay_Po]

Use bare wire, without of an insulation. You may use larger flexible wire if you split the thick wire strand into single wires.
I believe the most hard work will be de-soldering of existing jumper pins. You may heat the pin from bottom side until the top plastic start to melt and you will be able to pull the pin by a tweezers. Don't pull to early and too strong to not pull out the PCB traces. After you clear the holes from old jumpers, place new ones.

Step one. Prepare a thin bare wire from a larger flexible wire strand:

  Step_one_single_wire.JPG (Size: 52.79 KB / Downloads: 346)


Step two. Bend the wire to insert into the holes:

  Step_two_bend_it.JPG (Size: 109.76 KB / Downloads: 345)


Step three. Insert the wire:

  Step_three_insert_into_the_holes.JPG (Size: 28.52 KB / Downloads: 522)


Step four. Solder it using a neutral soldering flux:

  Step_four_solder_it.JPG (Size: 38.11 KB / Downloads: 351)


Step five. Cut the tails.