are the usb ports on rock64 on separate bus?

[shome]

Are all the USB ports on the rock64 on separate bus. I dont have a rock64, else I could check using lsusb on linux.

I need to connect camera and a sensor on two different USB ports. If they are on the same bus it results to decreased or dropped frames from the camera.

If anyone operating linux on rock64 can give me the output of lsusb command, it would be helpful.

[evilbunny]

Are all the USB ports on the rock64 on separate bus. I dont have a rock64, else I could check using lsusb on linux.

I need to connect camera and a sensor on two different USB ports. If they are on the same bus it results to decreased or dropped frames from the camera.

If anyone operating linux on rock64 can give me the output of lsusb command, it would be helpful.

Code:

# lsusb  -t
/:  Bus 05.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 5000M
   |__ Port 1: Dev 2, If 0, Class=Mass Storage, Driver=usb-storage, 5000M
/:  Bus 04.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 480M
/:  Bus 03.Port 1: Dev 1, Class=root_hub, Driver=ohci-platform/1p, 12M
/:  Bus 02.Port 1: Dev 1, Class=root_hub, Driver=ehci-platform/1p, 480M
   |__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 480M
       |__ Port 1: Dev 3, If 0, Class=Hub, Driver=hub/4p, 480M
       |__ Port 2: Dev 7, If 0, Class=Human Interface Device, Driver=usbhid, 1.5M
       |__ Port 2: Dev 7, If 1, Class=Human Interface Device, Driver=usbhid, 1.5M
       |__ Port 3: Dev 5, If 0, Class=Vendor Specific Class, Driver=cp210x, 12M
       |__ Port 4: Dev 6, If 0, Class=Vendor Specific Class, Driver=ftdi_sio, 12M
/:  Bus 01.Port 1: Dev 1, Class=root_hub, Driver=dwc2/1p, 480M