PINE64   ›   ROCKPRO64   ›   General Discussion on ROCKPRO64   ›   Production defects

Thread Closed 
Production defects
lucho
Pine Adept
***
Joined: Jun 2018
Posts: 27

Reputation: 1
#3
06-18-2018, 11:59 AM
It's not necessarily hand-soldered. Pick-and-place machines can be programmed to rotate the component at any angle. I don't think that either of these photos illustrates a problem. But it's interesting to know whether each produced board is tested and how it's done, including whether each interface is tested and how.
Thread Closed 


Messages In This Thread
Production defects - by mmatyas - 06-18-2018, 08:08 AM
RE: Production defects - by wis - 06-18-2018, 10:14 AM
RE: Production defects - by lucho - 06-18-2018, 11:59 AM
RE: Production defects - by wis - 06-18-2018, 12:17 PM
RE: Production defects - by mmatyas - 06-19-2018, 02:32 AM
RE: Production defects - by pfeerick - 06-19-2018, 03:10 AM
RE: Production defects - by mmatyas - 06-19-2018, 05:22 AM
RE: Production defects - by lucho - 06-19-2018, 07:02 AM
RE: Production defects - by dkryder - 06-19-2018, 02:16 PM
RE: Production defects - by mmatyas - 06-19-2018, 04:53 PM
RE: Production defects - by pfeerick - 06-19-2018, 08:21 PM
RE: Production defects - by Luke - 06-20-2018, 06:50 AM
RE: Production defects - by tllim - 06-20-2018, 05:08 PM
RE: Production defects - by pfeerick - 06-21-2018, 02:00 AM
RE: Production defects - by tllim - 06-24-2018, 08:19 PM
RE: Production defects - by Firesped - 07-24-2018, 12:04 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)