For those with PhoenixCard "Error" during Burn
(04-04-2016, 04:23 AM)Andrew2 Wrote:
(04-04-2016, 03:16 AM)Keex Wrote:
(04-03-2016, 02:08 PM)tllim Wrote: Thanks on the tips. I also use Diskpart to clean the SD partition. Just need to be extra careful not to clean your harddisk. My advise after launch diskpart, first action is immediately select to your SD card disk number to avoid any accidental mistake.
.. TL

You are right, I added another point in the steps to check the selected disk.

Sorry, but you're collecting here wrong/misleading 'information' (you should keep in mind that while Pine64 might be new the whole 'Android on Allwinner hardware' story is a bit older and everything you might wonder about is known since years).

When Phoenix Card is used in startup mode then the first step is cleaning out the first sectors of the card and writing an appropriate MBR + partition table to it that matches the card's size. Therefore using any tool like Dispart or SD Formatter is not only useless but dangerous instead (since you might wipe out your harddisk instead). It will later always look like this on the card (the first partition's size adjusted to use all available disk space):

Device     Boot   Start      End  Sectors  Size Id Type
/dev/sda1       5251072 15521790 10270719  4.9G  b W95 FAT32
/dev/sda2  *      73728   139263    65536   32M  6 FAT16
/dev/sda3             1  5251072  5251072  2.5G 85 Linux extended
/dev/sda5        139264   172031    32768   16M 83 Linux
/dev/sda6        172032   204799    32768   16M 83 Linux
/dev/sda7        204800  3350527  3145728  1.5G 83 Linux
/dev/sda8       3350528  3383295    32768   16M 83 Linux
/dev/sda9       3383296  3448831    65536   32M 83 Linux
/dev/sda10      3448832  5021695  1572864  768M 83 Linux
/dev/sda11      5021696  5054463    32768   16M 83 Linux
/dev/sda12      5054464  5087231    32768   16M 83 Linux
/dev/sda13      5087232  5251071   163840   80M 83 Linux

Then: Phoenix Card has some built-in checks relying on checksumming to verify whether some parts have been written correctly (does not apply to the largest part unfortunately). In case Phoenix Card throws errors then this is a sign of data corruption maybe caused by a bad (faulty or counterfeit) SD card or an SD card reader starting to corrupt data (well known problem with some USB readers that start to overheat and corrupt data after a certain amount of constant writing --> use USB2.0 when first connected to USB3.0, check the whole setup with one of the two tools below).

So instead of trying to workaround these issues ejecting/reinserting the card (which might work if speed negotiation between host and card reader might be adjusted -- check Device Manager) the only reasonable strategy is to stop at the very first error and check card reader with inserted SD card using H2testw or f3. Anything else is simply fooling yourself and most probably creating an Android image containing bit flips that lead to all sorts of random problems later.

Good information that is true I guess, but i think the advantage of the Diskpart step is that in some cases the partitions on the SD card can be pretty messed up from previous failed attempts (mine was) and this assured at least some vanilla state that PhoenixCard then could work of.
I am not claiming that everything here is correct, needed or even a good idea. It can however work and I myself was really about to give up before trying it this way. I could have tried even more than two different readers/adapters, I could have bought some more SD cards but this would be just as hit&miss as just counting on some bit errors not mattering. Trying the latter though is certainly cheaper and I have yet to discover a problem (apart from the wrong RAM size you pointed out to me in the other thread, but that's a different problem).
If will add a disclaimer to the original post though to let people know about your concerns.

Messages In This Thread
RE: For those with PhoenixCard "Error" during Burn - by Keex - 04-04-2016, 08:13 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  PBP Debian 11 GRUB install error zlth 2 2,158 11-18-2022, 07:42 AM
Last Post: zlth
  Invalid package error in Manjaro-ARM? Easy fix 98cwitr 0 1,672 05-23-2022, 08:49 AM
Last Post: 98cwitr
Information Booting Ubuntu stops with 16 error messages clawinus 0 2,699 11-05-2016, 03:45 PM
Last Post: clawinus
  SD card burn img size problems stephen0205 17 24,217 09-22-2016, 06:28 AM
Last Post: tkaiser
  Image Burn Issue and Power Auto Off Issue Mohit B 3 6,389 08-02-2016, 09:35 AM
Last Post: MarkHaysHarris777
  Script Not Found error using PhoenixCard Ghost 4 21,292 07-16-2016, 08:01 PM
Last Post: Ghost
  Error formatting Memory Card Astondb5 10 16,151 07-06-2016, 07:31 PM
Last Post: jamesread90

Forum Jump:

Users browsing this thread: 1 Guest(s)