ROCK64 Acrylic Enclosure Assembly
#1
Has anyone installed his ROCK64 in the 'ROCK64 ACRYLIC OPEN ENCLOSURE'?  There don't appear to be any assembly instructions....  From the product photo, it looks like the board is supposed to be pressed onto the toothed brass standoffs that are included with the enclosure hardware but the mounting holes on the board would have to be opened-up a bit in order to be pressed on to the standoffs and not damage the board.  I don't want to open up the holes if there's something I'm missing regarding the assembly...

Thanks!

Ron
  Reply
#2
(08-26-2017, 02:17 PM)ironhand Wrote: Has anyone installed his ROCK64 in the 'ROCK64 ACRYLIC OPEN ENCLOSURE'?  There don't appear to be any assembly instructions....  From the product photo, it looks like the board is supposed to be pressed onto the toothed brass standoffs that are included with the enclosure hardware but the mounting holes on the board would have to be opened-up a bit in order to be pressed on to the standoffs and not damage the board.  I don't want to open up the holes if there's something I'm missing regarding the assembly...

Thanks!

Ron

Board sits on top of the plastic standoffs built into the bottom plastic piece.
Long screw up from bottom plastic piece - toothed brass screws into that to secure the board the bottom piece of plastic.
The smaller screws are used to secure the DAC board if purchased.
If you are going to use the eMMC module, I'd recommend leaving off the top and the DAC as it's near impossible to jumper it when those are on.
  Reply
#3
Thanks @Farley56 - very much appreciated!
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  1wire DS18b20 on Rock64? mypineme 6 1,904 09-28-2021, 03:07 PM
Last Post: TRS-80
Information How to Setup Serial Console Cable Over the Rock64 SBC MarkHaysHarris777 9 20,633 09-28-2021, 10:52 AM
Last Post: lewiscamron72
  Rock64 4K60P HDR Media Board Computer 64 bit MarkHaysHarris777 8 9,304 07-14-2021, 11:52 PM
Last Post: jontumontu
  Any way to tell the rock64's hardware revision? kittyland 1 513 07-01-2021, 09:42 PM
Last Post: evilbunny
  Configuring Python GPIO Pin Control Rock64 www139 3 3,976 06-22-2021, 06:57 AM
Last Post: Mrfixit2001
  3D Printable Fan Mount Mod for the Open Enclosure + DT/Arduino Sketch for PWMing it CounterPillow 2 721 06-17-2021, 12:27 PM
Last Post: CounterPillow
  POE support for the Rock64 v3 h64poe 0 470 05-30-2021, 07:40 AM
Last Post: h64poe
  3D-Printable Button Pegs for the ROCK64 Aluminium Case CounterPillow 1 695 05-21-2021, 05:44 PM
Last Post: tllim
  How to enable ES9023-based DAC hat on Rock64? lowry 2 970 03-18-2021, 03:44 PM
Last Post: zborgerd
  Display options for the Rock64 joey49 1 1,444 11-23-2020, 09:52 AM
Last Post: joey49

Forum Jump:


Users browsing this thread: 1 Guest(s)