PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   Pi2, Euler and Exp GPIO Ports   ›   connect lipo battery to euler bus

connect lipo battery to euler bus
pfeerick
Moderator
*****
Moderators
Joined: May 2016
Posts: 1,361

Reputation: 118
#8
09-08-2016, 04:46 AM
(09-07-2016, 09:08 AM)UnixOutlaw Wrote: So I'm getting less than 4.5 hours from 2500 mAh battery...  As a comparison - I can get about 12 hours on an NTC CHIP running with a 2000 mAh battery...

If that battery was fully charged, and was genuinely capable of 2500mah, I'd be thinking it was nearer to 6 hours. Is this with a wifi module? I'll have to check what the power consumption of the board is again... I seem to think it was in the 300mah range when idle... but it's been a while since I've seen the readings when not trying to flog the poor thing! Wink

Hey MarkHaysHarris777, is that with the official battery? Is it holding it's capacity so far?
pine64 wiki, linux-sunxi Pine64 wiki, the board/connector layout & pinout of the Raspberry Pi/Euler/EXP connectors
  Reply


Messages In This Thread
RE: connect lipo battery to euler bus - by pfeerick - 09-08-2016, 04:46 AM
RE: connect lipo battery to euler bus - by peteh - 09-10-2016, 02:51 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  +LTS/SOPINE +PINEBOOK configuring Euler Bus pin generate interrupt RANJITT76 0 2,465 01-10-2019, 02:45 AM
Last Post: RANJITT76
  Mapping Euler bus DC in and 5v DC out pins g_t_j 8 10,622 07-02-2016, 09:30 PM
Last Post: tllim
Question What exactly is a Euler Bus? Ghost 10 37,883 05-06-2016, 06:49 PM
Last Post: tllim
  Euler Bus hrh1818 4 13,964 01-29-2016, 01:56 PM
Last Post: tllim

Forum Jump:


Users browsing this thread: 2 Guest(s)