04-15-2023, 02:11 PM
(This post was last modified: 04-15-2023, 02:11 PM by tpaul.
Edit Reason: Typo
)
I've noticed that the DC LED stays illuminated after I've disconnected the DC barrel power completely, but only if the serial port is still attached (just GND, TX, and RX via a USB Serial adapter.)
Are these pins also leaking power as mentioned here for the A64+? I use the EXP pins on my A64+ plus but they are absent on the RockPro64.
I intend to leave a serial connection attached to this board permanently so just want to ensure it's not going to cause damage long-term or if there's any way I can prevent it.
Are these pins also leaking power as mentioned here for the A64+? I use the EXP pins on my A64+ plus but they are absent on the RockPro64.
I intend to leave a serial connection attached to this board permanently so just want to ensure it's not going to cause damage long-term or if there's any way I can prevent it.