Specifications of fan connectors?

[kuleszdl]

Hi,

I'm not an expert in connectors but wanted to connect a usual 3pin non-PWM fan to my RP64. However, I can't find information about the connectors for the fans on the RP64 board. Do they conform to the following?:

    GH 1,25mm

Many thanks in advance.

[tllim]

Hi,

I'm not an expert in connectors but wanted to connect a usual 3pin non-PWM fan to my RP64. However, I can't find information about the connectors for the fans on the RP64 board. Do they conform to the following?:

    GH 1,25mm

Many thanks in advance.

2 pin PH connector, please noted that you need to use 12V fan.

[kuleszdl]

Thank you @tllim - I assume it is PH 2.0mm then, right?

[kuleszdl]

FTR: PH 2.0mm worked perfectly. I now have more "headroom" for the cables.

I also found that 4pin PWM fans *do* work as well, but regulating them cannot be done as well as with the regular 3pin fans. Actually, there is one 4pin PWM fan that has a depth of just 10.8mm (I didn't test it myself):

Akasa Slimfan, 80mm (AK-FN076)

My current setup runs with the following fan (15mm depth):

Titan TFD-8015M12Z

It is relatively quiet even at full power.