PINE64   ›   PinePhone   ›   PinePhone Hardware   ›   Where are the HW kill switches located?

Thread Closed 
Where are the HW kill switches located?
p1trson
Pine Adept
***
Joined: Dec 2019
Posts: 78

Reputation: 11
#6
12-31-2019, 07:24 AM
(12-31-2019, 03:12 AM)bcnaz Wrote: You can remove the rear cover with just your fingernail.
**  Then the switches are pretty obvious,  see the pictures in the wiki.
 ****   IF you MUST have them on the outside of the case,     ...    They are on the outside on a Libre5....

So I also really don't understand the reason to have the hw switches covered all the time. I hope that this applies only for dev versions. As it was mentioned sometimes you want to quickly turn on or off some of the switches - it's very inconvenient to have them behind the cover.
Thread Closed 


Messages In This Thread
RE: Where are the HW kill switches located? - by p1trson - 12-31-2019, 07:24 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  USB-C CC pins are pulled to the GND by AW3512 (VCONN switches) when VCONN is off fsflover 41 51,868 06-17-2021, 04:54 PM
Last Post: feklee
  Is the PinePhone only Pine-device with hardware switches? harrm 1 2,270 01-23-2021, 12:29 AM
Last Post: KC9UDX
  Only enable modem when needed with kill switches sokolgeo 2 4,146 09-20-2020, 04:40 AM
Last Post: sokolgeo
  hardware switch wishlist/discussion - switches on the outside? mypine 7 7,516 04-12-2020, 10:40 AM
Last Post: wibble
  Kill switches blicken 2 3,877 02-08-2020, 03:51 PM
Last Post: wibble

Forum Jump:


Users browsing this thread: 3 Guest(s)