PINE64   ›   ROCKPRO64   ›   General Discussion on ROCKPRO64   ›   Production defects

Thread Closed 
Production defects
pfeerick
Moderator
*****
Moderators
Joined: May 2016
Posts: 1,361

Reputation: 118
#13
06-20-2018, 03:54 AM
(06-20-2018, 03:32 AM)superpat Wrote: The larger fawn colured SMD is not fitted or has been removed, but the smaller black SMD has been turned 90 downwards and is soldered to the lower pad same as yours.

That means your and my boards are exactly the same Patrick... the capacitor has been removed/not fitted, and the resistor turned. Wink Good to know! Smile
pine64 wiki, linux-sunxi Pine64 wiki, the board/connector layout & pinout of the Raspberry Pi/Euler/EXP connectors
Thread Closed 


Messages In This Thread
Production defects - by mmatyas - 06-18-2018, 08:08 AM
RE: Production defects - by wis - 06-18-2018, 10:14 AM
RE: Production defects - by lucho - 06-18-2018, 11:59 AM
RE: Production defects - by wis - 06-18-2018, 12:17 PM
RE: Production defects - by mmatyas - 06-19-2018, 02:32 AM
RE: Production defects - by pfeerick - 06-19-2018, 03:10 AM
RE: Production defects - by mmatyas - 06-19-2018, 05:22 AM
RE: Production defects - by lucho - 06-19-2018, 07:02 AM
RE: Production defects - by dkryder - 06-19-2018, 02:16 PM
RE: Production defects - by mmatyas - 06-19-2018, 04:53 PM
RE: Production defects - by pfeerick - 06-19-2018, 08:21 PM
RE: Production defects ITS A MOD!!!!! - by pfeerick - 06-20-2018, 03:54 AM
RE: Production defects - by Luke - 06-20-2018, 06:50 AM
RE: Production defects - by tllim - 06-20-2018, 05:08 PM
RE: Production defects - by pfeerick - 06-21-2018, 02:00 AM
RE: Production defects - by tllim - 06-24-2018, 08:19 PM
RE: Production defects - by Firesped - 07-24-2018, 12:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)