swap SPI_CLK_M2 and SPI_CSN0_M2
#11
Assuming you want to connect a second SPI slave-device you'll need a second dedicated CS signal (one of the available GPIO pins), and make sure only one of them is active (low) at any given time.

It's probably also a good idea to put a ~200Ohm resistor on your MISO line when you're experimenting with this, just in case Wink
  Reply


Messages In This Thread
swap SPI_CLK_M2 and SPI_CSN0_M2 - by dontpostalot - 12-18-2017, 10:25 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by xalius - 12-19-2017, 09:16 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by xalius - 12-19-2017, 04:14 PM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by coldfish - 12-26-2017, 12:32 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-08-2018, 08:00 PM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-09-2018, 08:14 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-10-2018, 06:40 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by dontpostalot - 01-10-2018, 07:28 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-10-2018, 10:40 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-11-2018, 07:59 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by mcerveny - 08-18-2018, 02:22 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)