10-05-2017, 05:39 AM
Hi,
I would like to use the uart 1 for connecting the BT module. The UART 2 is used for debug or console logs.
What steps should I follow to configure the UART 1 in rock64 ? I am using linux image Jessie.
Do I need to configure both uboot and kernel with GPIO3_A4 as Tx and GPIO3_A6 as Rx pin?.
If it is already configured then which tty port should I connect to?
Can someone please give details for the same?
Is there any documentation for using the GPIO, configuring peripheral drivers?
Regards,
Ankit Channa
I would like to use the uart 1 for connecting the BT module. The UART 2 is used for debug or console logs.
What steps should I follow to configure the UART 1 in rock64 ? I am using linux image Jessie.
Do I need to configure both uboot and kernel with GPIO3_A4 as Tx and GPIO3_A6 as Rx pin?.
If it is already configured then which tty port should I connect to?
Can someone please give details for the same?
Is there any documentation for using the GPIO, configuring peripheral drivers?
Regards,
Ankit Channa
