System LED mounting option using header pins and remote LED for use in the ABS case

[MarkHaysHarris777]

   

The pic above shows the modification to the PineA64 board , by adding just the male header pins to the board where the system LED is marked out.  You'll notice how I have removed the pins from the header spacer and soldered them directly into the pcb , at the right height of course. The female-male jumper wires have been soldered to the system LED ( I used a 5mm low power 'bright' LED here ) and they may be plugged into the male header pins easily without difficulty.

   

In the pic above I have connected the system LED via jumper cables to my male header pins in preparation for mounting this board in my Radio Shack enclosure.