08-06-2016, 02:47 PM
i can't find an existing thread on this, so posting new.
can i connect a lipo battery directly to pin 3 on the euler bus (and ground on pin 6 of course)? that is, is this an V-IN pin or just V-OUT?
would i also have to connect a 10k resistor (or what kind of thermister?) to the temp sensor connection on pin 5? i suspect yes.
i dont have a 3 pin JST connector (still in the mail) but i did purchase a battery so i'd like to get the ball rolling here.
can i connect a lipo battery directly to pin 3 on the euler bus (and ground on pin 6 of course)? that is, is this an V-IN pin or just V-OUT?
would i also have to connect a 10k resistor (or what kind of thermister?) to the temp sensor connection on pin 5? i suspect yes.
i dont have a 3 pin JST connector (still in the mail) but i did purchase a battery so i'd like to get the ball rolling here.
