11-27-2021, 11:00 AM
I followed the various instructions and put onto a microSD card.
This is the output. Did I compile it right?
This is the output. Did I compile it right?
Code:
U-Boot SPL board init
U-Boot SPL 2017.09-g1372a46 #root (Nov 27 2021 - 16:35:48)
unknown raw ID phN
unrecognized JEDEC id bytes: 00, 00, 00
Trying to boot from MMC2
## Verified-boot: 0
## Checking atf-1 0x00040000 ... sha256+ OK
## Checking uboot 0x00a00000 ... sha256+ OK
## Checking fdt 0x00b22708 ... sha256+ OK
## Checking atf-2 0xfdcc9000 ... sha256+ OK
## Checking atf-3 0xfdcd0000 ... sha256+ OK
## Checking optee 0x08400000 ... sha256+ OK
Jumping to U-Boot(0x00a00000) via ARM Trusted Firmware(0x00040000)
Total: 265.827 ms
INFO: Preloader serial: 2
NOTICE: BL31: v2.3():v2.3-135-gcda1658bc-dirty:xsf
NOTICE: BL31: Built : 14:19:26, Jun 1 2021
INFO: GICv3 without legacy support detected.
INFO: ARM GICv3 driver initialized in EL3
INFO: pmu v1 is valid
INFO: dfs DDR fsp_param[0].freq_mhz= 1056MHz
INFO: dfs DDR fsp_param[1].freq_mhz= 324MHz
INFO: dfs DDR fsp_param[2].freq_mhz= 528MHz
INFO: dfs DDR fsp_param[3].freq_mhz= 780MHz
INFO: Using opteed sec cpu_context!
INFO: boot cpu mask: 0
INFO: BL31: Initializing runtime services
INFO: BL31: Initializing BL32
I/TC:
I/TC: Start rockchip platform init
I/TC: Rockchip release version: 1.0
I/TC: OP-TEE version: 3.6.0-307-g0b06ae94 #1 Fri May 7 01:52:27 UTC 2021 aarch4
I/TC: Initialized
INFO: BL31: Preparing for EL3 exit to normal world
INFO: Entry point address = 0xa00000
INFO: SPSR = 0x3c9
U-Boot 2017.09-g1372a46 #root (Nov 27 2021 - 16:36:25 +0000)
Model: Pine64 RK3566 Quartz64 Board
PreSerial: 2, raw, 0xfe660000
DRAM: 4 GiB
Sysmem: init
Relocation Offset: ed356000, fdt: eb9f93f8
Using default environment
no mmc device at slot 1
dwmmc@fe2b0000: 1 (SD), dwmmc@fe2c0000: 2, sdhci@fe310000: 0
Bootdev(atags): mmc 1
MMC1: Legacy, 50Mhz
PartType: EFI
No misc partition
boot mode: None
FIT: No boot partition
No resource partition
Failed to load DTB
Failed to get kernel dtb, ret=-19
io-domain: OK
Model: Pine64 RK3566 Quartz64 Board
rockchip_set_serialno: could not find efuse/otp device
CLK: (sync kernel. arm: enter 816000 KHz, init 816000 KHz, kernel 0N/A)
apll 816000 KHz
dpll 528000 KHz
gpll 1188000 KHz
cpll 1000000 KHz
npll 24000 KHz
vpll 24000 KHz
hpll 24000 KHz
ppll 100000 KHz
armclk 816000 KHz
aclk_bus 150000 KHz
pclk_bus 50000 KHz
aclk_top_high 300000 KHz
aclk_top_low 200000 KHz
hclk_top 150000 KHz
pclk_top 50000 KHz
aclk_perimid 300000 KHz
hclk_perimid 150000 KHz
pclk_pmu 50000 KHz
Net: clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -2.
Hit key to stop autoboot('CTRL+C'): 0
## Booting FIT Image FIT: No boot partition
FIT: No FIT image
Could not find misc partition
ANDROID: reboot reason: "(none)"
optee api revision: 2.0
TEEC: Waring: Could not find security partition
Not AVB images, AVB skip
android_image_load_by_partname: Can't find part: boot
Android image load failed
Android boot failed, error -1.
switch to partitions #0, OK
mmc1 is current device
Failed to mount ext2 filesystem...
** Unrecognized filesystem type **
MMC error: The cmd index is 0, ret is -110
mmc_init: -110, time 4
starting USB...
Bus dwc3@fcc00000: usb maximum-speed not found
Register 2000140 NbrPorts 2
Starting the controller
USB XHCI 1.10
Bus dwc3@fd000000: usb maximum-speed not found
Register 2000140 NbrPorts 2
Starting the controller
USB XHCI 1.10
scanning bus dwc3@fcc00000 for devices... 1 USB Device(s) found
scanning bus dwc3@fd000000 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Device 0: unknown device
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missind
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/00000000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/0000000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/000000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/00000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/0000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/000
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/00
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/0
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/default-arm-rockchip
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/default-arm
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22missine
Retrieving file: pxelinux.cfg/default
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22Configd
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22clk_ge.
clk_get_by_name(master_bus) failed: -22eqos_probe_resources() failed: -22=>