06-24-2021, 03:07 AM
(06-24-2021, 02:58 AM)Mpoint Wrote: Here you can see Line 3 BLE address of 2nd PineTime was introduce next to Raspberry Pi After removing line 7 BLE address PineTime https://pastebin.pl/view/9c6227a6So the first time (line7 was connected but now removed) still shows in the buffer of BLE
addrresses
But when I run wasptool it breaks and I am unable to use to to connect when I swap with another Pinetime. What is the correct procedure to perform a swap such that the wasptool will recognize the 2nd PineTime BLE address and connect to it rather than connecting to the one that is in the buffer of Raspberry Pi
When there are two devices of the same name coming up during a scan then wasptool --device PineTime won't make any difference because it will still pick the first one. However you can also use the MAC address rather than the name as an argument allowing you to select exactly the device you want:
wasptool --device EF:46:76:xx:xx:xx