04-30-2021, 05:25 PM
(This post was last modified: 04-30-2021, 05:27 PM by codebreaker.)
8bit: Thanks for the suggestions. I tried updating the anx7688 firmware as described in the link, no change. I have not tried solving the VCONN problem, as that requires desoldering a tiny solder joint. That will be my last resort.
kqlnut: Thanks. I actually hadn't thought of that, good idea. But the fact that just a usb cable with nothing attached turns the screen off makes me think its not that. But I will be mindful of power consumption going forward.
Can the pogo pins be utilized as a usb input?
kqlnut: Thanks. I actually hadn't thought of that, good idea. But the fact that just a usb cable with nothing attached turns the screen off makes me think its not that. But I will be mindful of power consumption going forward.
Can the pogo pins be utilized as a usb input?