04-08-2021, 01:20 AM
(This post was last modified: 04-08-2021, 01:21 AM by fotastisch.
Edit Reason: additional information
)
(04-07-2021, 04:52 AM)fotastisch Wrote: Hi,
I just received my Pinecil and wanted to check its features. When I plug it in, even if set at reasonable temperatures below 200 °C, the tip starts glowing after a few seconds...
Is this a known problem?
Seems to be a broken temperature measurement (defunct temperature converter on the board itself?). Measured temperature on the display never exceeds 40 °C even when a water drop on the tip starts boiling (tested for additional soldering tips, all show same behaviour).