02-12-2021, 09:13 PM
(This post was last modified: 02-12-2021, 09:13 PM by FrancisTheodoreCat.)
Got my PineCube today, and ran into a snag getting the camera working.
I'm running the latest Armbian Focal build (21.02.1 on kernel 5.10.12-sunxi), and whenever I try and access the camera module, whether via ffmpeg or gstreamer, I get the following errors in the syslog:
Also happens about 13 seconds after boot.
Checked the CSI cable, and it seems to be properly seated on both ends. Any ideas?
(I think I got the cedar hardware H264 acceleration gstreamer plugin working, but this kinda derailed any actual testing.)
I'm running the latest Armbian Focal build (21.02.1 on kernel 5.10.12-sunxi), and whenever I try and access the camera module, whether via ffmpeg or gstreamer, I get the following errors in the syslog:
Quote:[ 2518.009350] ov5640 1-003c: ov5640_read_reg: error: reg=300a
[ 2518.014994] ov5640 1-003c: ov5640_set_power_on: failed to read chip identifier
Also happens about 13 seconds after boot.
Checked the CSI cable, and it seems to be properly seated on both ends. Any ideas?
(I think I got the cedar hardware H264 acceleration gstreamer plugin working, but this kinda derailed any actual testing.)