12-15-2020, 09:43 AM
(12-12-2020, 11:27 PM)NormandC Wrote: Hello all,
I'm reviving this topic, has anyone done any more progress on that front?
(02-17-2020, 01:19 PM)tophneal Wrote: I want to see if I can bring the decal closer to the edge/bezel of the case sides. Would anyone be able to export the pieces of the back panel as highlighted here? I'm trying in Fusion360, but I'm having no luck.Are you still looking for this? In your screenshot, you highlighted the rounded edges as well. Do you mean to flatten them to get a complete single face? It's often tricky to do in CAD, but I could give it a try.
The corners would create creases when folding them over the back cover; a solution may be to make two small triangular notches for each corner.
I don't think I ever quite got the file how I was hoping to. If you're willing to give it a go, that'd be awesome!
You're right, it most likely would need a small slit/triangle removed from the corners. I also want to try using some thinner, stretchier vinyl (like is used for some vehicle graphics) to see how creases when laid down.
