Thermal imaging solution board for the PinePhone board

[jnpine]

Presumably it would work with libraries like the adafruit python one:
https://cdn-learn.adafruit.com/downloads...sensor.pdf

If it's aimed at the pinephone rather than more generic usage it should probably have the option to connect direct to the pogo pins similar to the way the breakout cable does. I'd be careful of proximity to the antenna.

I guess you've already seen Martijn Braam's post about the MLX90640:
https://blog.brixit.nl/making-a-backcove...pinephone/

I tried the Adafruit one without success as of today. (Now reading Martjin´s post, as the work is aimed for the Raspberry Pi this might be why).

The direct connection could be for a later stage, the current system is aimed for prototyping. 

Thanks a lot for the link, I have not seen it before.  I will for sure take a closer look at Martjin´s work!.