05-04-2016, 04:36 AM
Tarjei85, that was a quick reply. I looked over the model again.
I'm still quite new at 3d printing, about 3 months.
I'll try printing one of the side panels, where the outlets are, and see how that turns out. My concern about then was the circular recess in each corner. If the prints okay, then its only the "feet" side and the "?" that could pose a challenge. I might have to resort to slicing off the feet and just stick on rubber feet and for the "?", maybe print that as 2 parts. But I'll get back to you :-).
I'm still quite new at 3d printing, about 3 months.
I'll try printing one of the side panels, where the outlets are, and see how that turns out. My concern about then was the circular recess in each corner. If the prints okay, then its only the "feet" side and the "?" that could pose a challenge. I might have to resort to slicing off the feet and just stick on rubber feet and for the "?", maybe print that as 2 parts. But I'll get back to you :-).
