11-07-2020, 11:22 AM
(11-07-2020, 03:02 AM)peperjohnny Wrote: I was doing a zypper refresh and a zypper update and downgraded my kernel afterwards, but it should be possible to update the packages one by one by "zypper install package".
I'm still running from a SD card, as I'm running Arch with Plasma desktop on my emmc.
I had good results with putting a jumpdrive sd card in and then putting the image in via etcher. Dunno if jumpdrive has been updated since, because it had the old panel driver, last time I used it.
The session thing is a good idea I think.
Lastly the main dev Adam Pigg will have an EA tab soon and with that the flash-it script will probably work again.
Sounds like a plan
When i tried the etcher - it flashed but would not boot
All the files were there though
I even tried to flash direct seperately with Flash it
All of which can wait
Minor update is the bluetooth woke up and went on and off a few times so ---it is working and so is sound (ish)! Again intermittently
Listen I have lots of time to wait for this as I am now busy trying this out on a OP3T (real fast but no bluetooth :-( ) and acquired a cheap OP6T - beastie phone which work with Sailfish like a dream....
I was going to spring the cash on a Pinephone but went for the OP6T which t leqst works with pretty much everything except finger print and is lightning fast.
For me the pinetab is good enough to have the emmc flashed (now I have learnt to do the Ubuntu again I am less worried about bricking it) so will leave it on the SD Card for now and then retry when the flash it is fixed again.
Regarding a session - which timezone are you both in - think Adam is in the UK (I am too) but we could set up a small session this week?