Need help with extra info to resize partition in EMMC
10-26-2020, 06:04 AM
(This post was last modified: 10-26-2020, 10:09 AM by Arwen.
Edit Reason: Removed image
)
Hello,
I am new here (and gald to be here). I have the postmarketOS edition, and I would like to flash the EMMC with the last Arch image.
I have the Jump Drive on a SD card and I can boot from it. Also no problem to expose the EMMC drive in my Linux laptop.
Until there all good, but then I become confuse and wnat to be sure I won't make an error :
The wiki instructions says to run cfdisk to resize the partition., this is OK. But I am not sure WHICH partition to resize ?
I can see 2 partitions, the small boot one and a other bigger (Lucks encrypted)
[Moderator edit: Removed image that did not display properly]
Sorry if the question was already answered (could not find it) and sorry for what may be a noob question.....
Do I need to resize (from the image above) sdg1 or sdg2 ? And to be 100% sure.... Must it be ext2 ? Can it be ext 4 ?
Thanks in advance for any help !
I am new here (and gald to be here). I have the postmarketOS edition, and I would like to flash the EMMC with the last Arch image.
I have the Jump Drive on a SD card and I can boot from it. Also no problem to expose the EMMC drive in my Linux laptop.
Until there all good, but then I become confuse and wnat to be sure I won't make an error :
The wiki instructions says to run cfdisk to resize the partition., this is OK. But I am not sure WHICH partition to resize ?
I can see 2 partitions, the small boot one and a other bigger (Lucks encrypted)
[Moderator edit: Removed image that did not display properly]
Sorry if the question was already answered (could not find it) and sorry for what may be a noob question.....
Do I need to resize (from the image above) sdg1 or sdg2 ? And to be 100% sure.... Must it be ext2 ? Can it be ext 4 ?
Thanks in advance for any help !