USB-C CC pins are pulled to the GND by AW3512 (VCONN switches) when VCONN is off

[fsflover]

My apologies if already answered, but:

1) Is the hardware fix applicable to BH phones?
2) If yes, what are the necessary steps to enable OTG on the software side?  After removing the regulators I tried bott the nightly Mobian and PMOS ANX image and only get stuff along the lines of "anx7688 0-0028: read failed (-6)".

1) Yes. They even promised to setup repair shops for both CE and BH owners.

"When we sold Braveheart PinePhones we made a promise to the early adopters that we won’t leave them behind, so I’d like to extend the offer for fixing the CC pin issue to all Braveheart owners too." https://www.pine64.org/2020/07/15/july-u...e-version/

2) It probably is impossible. The other end will still not know about the issue.