USB-C CC pins are pulled to the GND by AW3512 (VCONN switches) when VCONN is off
#17
My apologies if already answered, but:

1) Is the hardware fix applicable to BH phones?
2) If yes, what are the necessary steps to enable OTG on the software side? After removing the regulators I tried bott the nightly Mobian and PMOS ANX image and only get stuff along the lines of "anx7688 0-0028: read failed (-6)".
  Reply


Messages In This Thread
RE: USB-C CC pins are pulled to the GND by AW3512 (VCONN switches) when VCONN is off - by oaklarch - 07-16-2020, 05:14 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Kill switches for Wifi/Bluetooth does not work luxgiammi 0 119 10-14-2024, 03:34 PM
Last Post: luxgiammi
  pine64 keyboard pogo 'no-go' pins --- 3 3,190 04-29-2022, 04:59 AM
Last Post: Humid Stylus
  PP v1.2 VCONN question m4xx3d0ut 0 1,023 03-18-2022, 12:26 PM
Last Post: m4xx3d0ut
  what are these pins above modem chip? zetabeta 1 1,935 12-13-2021, 04:38 AM
Last Post: kqlnut
  Pogo pins power clarification - reading schematics bokomaru 48 52,019 06-19-2021, 10:46 AM
Last Post: bokomaru
  Is the PinePhone only Pine-device with hardware switches? harrm 1 2,568 01-23-2021, 12:29 AM
Last Post: KC9UDX
  Where are the HW kill switches located? WaldoTheRanger 11 16,183 10-04-2020, 02:23 AM
Last Post: WaldoTheRanger
  Only enable modem when needed with kill switches sokolgeo 2 4,613 09-20-2020, 04:40 AM
Last Post: sokolgeo
  hardware switch wishlist/discussion - switches on the outside? mypine 7 8,323 04-12-2020, 10:40 AM
Last Post: wibble
  Kill switches blicken 2 4,252 02-08-2020, 03:51 PM
Last Post: wibble

Forum Jump:


Users browsing this thread: 7 Guest(s)