03-07-2020, 01:32 PM
(03-06-2020, 08:11 PM)lupyuen Wrote: Can we solve this with a 3D printed back cover? Plus maybe a custom PCB? I'm sure this is something that we can throw money and solve ;-)
Using the magnets as SWCLK and SWDIO should be a very neat way to make the watch wearable whilst keeping SWD available for debugging and disaster recovery. The idea is to run thin wires from the SWD pins to the backs of the magnets and then carefully drill access holes from the other side so pogo pins can make contact with the magnet casing. There's probably some static risk but if a very find drill bit is used the risk should be pretty minimal.