04-17-2016, 11:31 AM
(04-17-2016, 11:22 AM)tkaiser Wrote:(04-17-2016, 11:09 AM)fire219 Wrote: It will respond to FEL mode, but to actually load anything through that seems impossible, since the A64 SoC acts different from most of the other Allwinner chips.
Be assured that the linux-sunxi kernel devs did FEL booting with Pine64 like crazy. This is confirmed to work.
Did you check voltage available to the board? Measuring test points? Don't forget that this board is prone to both undercurrent situations (using 'smart chargers' that provide only 500mA) and undervoltage (many/most USB cables are simply crap to power something with more than a few mA)
The board is getting 5.22v, measured off the Pi2 GPIO connector. This is using a Samsung 2A adapter.
I know they had used FEL, I just meant that it's over my head and the generic sunxi wiki directions don't work.
Community administrator and sysadmin for PINE64
(Translation: If something breaks on the website, forum, or chat network, I'm a good person to yell at about it)
(Translation: If something breaks on the website, forum, or chat network, I'm a good person to yell at about it)