Packaging considerations

[tllim]

some other smaller nit-picks after completing the initial setup.

* the screen protector is slightly off center(can be seen on the original picture as well)
* the screen protector had some air bubbles on the bottom part
* the screen protector applying sticker was difficult to get off, instead of coming off it actually started to pull the protector itself. I had to scratch it from the "not open" side to remove and it left lots of glue marks.

I'd say don't try to pre-apply the protector and just have it in the box for people to apply themselves. I understand it's difficult to get the process right in a production line setting. Or if placed on in the factory, remove the white-blue applying sticker before the glue gets stale.

Again, this is just feedback for later runs, and no qualms from me.

Noted, just pass your feedback to shipping team. Frankly speaking, I prefer hard foam type.