01-31-2020, 08:20 AM
some other smaller nit-picks after completing the initial setup.
* the screen protector is slightly off center(can be seen on the original picture as well)
* the screen protector had some air bubbles on the bottom part
* the screen protector applying sticker was difficult to get off, instead of coming off it actually started to pull the protector itself. I had to scratch it from the "not open" side to remove and it left lots of glue marks.
I'd say don't try to pre-apply the protector and just have it in the box for people to apply themselves. I understand it's difficult to get the process right in a production line setting. Or if placed on in the factory, remove the white-blue applying sticker before the glue gets stale.
Again, this is just feedback for later runs, and no qualms from me.
* the screen protector is slightly off center(can be seen on the original picture as well)
* the screen protector had some air bubbles on the bottom part
* the screen protector applying sticker was difficult to get off, instead of coming off it actually started to pull the protector itself. I had to scratch it from the "not open" side to remove and it left lots of glue marks.
I'd say don't try to pre-apply the protector and just have it in the box for people to apply themselves. I understand it's difficult to get the process right in a production line setting. Or if placed on in the factory, remove the white-blue applying sticker before the glue gets stale.
Again, this is just feedback for later runs, and no qualms from me.