04-05-2016, 03:24 AM
Hi,
I have just received my Pine A64 board and found that there was a little switch floating around
in the box with it (pic attached). The switch doesn't have any solder on so I don't think it's been knocked off
the board.
Does anybody know where it might go - and if I should solder it on? There are some holes
labelled "reset" that look like they might fit it?
Many thanks for any help.
I have just received my Pine A64 board and found that there was a little switch floating around
in the box with it (pic attached). The switch doesn't have any solder on so I don't think it's been knocked off
the board.
Does anybody know where it might go - and if I should solder it on? There are some holes
labelled "reset" that look like they might fit it?
Many thanks for any help.