Brushless Fan (5v) for Rock64 Clear Case Soft PWM Drive 2N2222

[merwone]

I was finally able to work on this Fan's project and I was wondering if someone could tell me if I connected everything in the right way since I have no experience whatsoever in electronics.

https://drive.google.com/open?id=0B3iAYb...JOMmdwYTJF

https://drive.google.com/open?id=0B3iAYb...Y5UmpSWFd3

https://drive.google.com/open?id=0B3iAYb...hRSlRRbWVv

https://drive.google.com/open?id=0B3iAYb...JvQTlhU1Rj

Now my question is... Where do I connect the green cable that is supposed to go to GPIO (Software pwm)? I am thinking to connect it to the gpio89 Pi P5+ bus  GPIO2_D1  pin(21) but is already occupied by a jumper wire cable that goes from gpio89 to gpio83.

I am lost to be honest

Hi Soichiro,

Did you manage to get your fan working?
Since I bought my rock64 2 years ago I haven't invested in proper cooling and struggle regularly to keep heat below 60 celsius.
I would appreciate if you could share you latest setup and hw you used?

thanks