Getting 12v from the board
06-07-2019, 06:52 PM
Hello,
(1) Beside splicing the SATA power cable (which comes with the SATA card) is there another place on the board where one can pick up the 12v line (for the 80mm fan I'm adding to the Pine64 NAS case)
(2) If I were to use 4 drives (2 x 3.5" and 2 x SSD) in the Pine64 NAS case, with a Marvell 88SE9230 4-PORT, is using a PSU 12v 8A OK to power the board OK? Otherwise what is the Amp limit?
(1) Beside splicing the SATA power cable (which comes with the SATA card) is there another place on the board where one can pick up the 12v line (for the 80mm fan I'm adding to the Pine64 NAS case)
(2) If I were to use 4 drives (2 x 3.5" and 2 x SSD) in the Pine64 NAS case, with a Marvell 88SE9230 4-PORT, is using a PSU 12v 8A OK to power the board OK? Otherwise what is the Amp limit?
