05-17-2019, 03:06 PM
Progress! When changing boot.cmd, I forgot to use mkimage to rebuild boot.scr. (Ok, fine, I didn't know I had to, and I missed the instruction at the bottom of the file!)
I still get garbage at first (presumably from the bootloader), but then I get a login prompt, and all is good. So this seems to mean that my USB-Serial adapter does not support 1500000 baud, but the bootloader is still running at that rate. Is there a way to change the bootloader's console baud rate, without access to the console during boot?
I still get garbage at first (presumably from the bootloader), but then I get a login prompt, and all is good. So this seems to mean that my USB-Serial adapter does not support 1500000 baud, but the bootloader is still running at that rate. Is there a way to change the bootloader's console baud rate, without access to the console during boot?