03-31-2019, 12:12 PM
Hi,
I don't have enough experience on linux base operating systems. Before I buy Rock64, I thought if I have a linux base operating system I can access to all linux programs. That was good if I could use this low consumption single board computer as a video converter. But when I load lxde bionic I figured out there is no software center. So I tried to install via command line but no success. After a few try I managed to install it with flatpak and all dependencies was installed successfully. Despite of all, it wasn't run. I think it is because of CPU architecture but after a few searches I found this thread:
https://www.raspberrypi.org/forums/viewt...5&start=50
Can any body explain to me can I use Hand brake on Rock64 or not?
Sent from my SM-G960F using Tapatalk
I don't have enough experience on linux base operating systems. Before I buy Rock64, I thought if I have a linux base operating system I can access to all linux programs. That was good if I could use this low consumption single board computer as a video converter. But when I load lxde bionic I figured out there is no software center. So I tried to install via command line but no success. After a few try I managed to install it with flatpak and all dependencies was installed successfully. Despite of all, it wasn't run. I think it is because of CPU architecture but after a few searches I found this thread:
https://www.raspberrypi.org/forums/viewt...5&start=50
Can any body explain to me can I use Hand brake on Rock64 or not?
Sent from my SM-G960F using Tapatalk