Tool to Control Fan - fanctl

[tuxd3v]

ahm.. ok
so what would you change?

please give me the numbers.. im not as good with these calculations

heheh, 
You changed the 'MAX_FAN_PWM' to 150, so it will max out at 150, its the beginning.. 

For the fan to run continuously, without stop,
Maybe the best would be to just comment the stop code( with "--" before it like you see below ), at almost the end of file:

Code:

-- Sleeping with Fan OFF, until next cicle
-- sleep( PROFILE:getQtimer( TEMP ) )

(...OTHER CODE ...)

-- Stop Fan
-- setFanpwm( 0 )

The fan will not stop in this way.. and you can lower the 'MAX_FAN_PWM' even more..it you want..

But in my opinion you should not touch 'MIN_FAN_PWM', because its the minimum..bellow that, the fan can stop depending of fan type..

It varies a lot..
For example:
in a fan 10mm, this value would be around 30-35 has minimum..
in a 20 mm fan, it would be at least between 35-40
I don't know the value for the NAS Fan case..., but 40 seems nice to me has minimum...

Because of that I used 40 for all, which is not so above 30, and more fans could be running with it..

Right now you are with a Function like this: 
   

So with a max temp of 60C, you will get 150 PWM.