(11-19-2018, 03:28 PM)tuxd3v Wrote:(11-18-2018, 01:59 PM)Girbur Wrote: Got it sorry
No problem,
You welcome
In fact I have not yet documented it, sorry for that.
Choose if you want one of those 3 profiles,
And adapt the timers in the line 97, in this function :
setTriggers = function( self, x )
You will see that for each range of temps are there some timers.
Quiet(the fan is stoped by this time in Seconds)
Run( The fan will run for that specified time in seconds )
You only need to change and then start ats again, and test the best option for your setup
Hey,
ok so i´ve played arround with these settings a bit but im not sattisfied with the result i produced
what i want to do is use Profile 3 or what ever and then i want the fan to always run but kinda slow so. this way it cools and is not as loud.
is that possible? if yes could you give me the numbers i need to put in and where?
Greetings
Steffen
p.s. i think i found it my selfe after i wrote this post
is this correct to change this setting: MAX_FAN_PWM?
I changed it to 150 and the fan is mutch quieter.
or am i wrong and did something fatal?