Hi everybody,
I just tried my new rockpro64 4GB board and I installed the 30mm tall heatsink to see how it performs (no fan).
After about 5-10 minutes of stress test using sbc-bench.sh -T 80 I found it to reach 75 °C.
At idle it is sitting at about 43 °C (still passively cooling 15 minutes after the end of the stress test)
The heatsink was installed using some NOCTUA NH-H1 thermal compound I had laying around (I didn't use the thermal pad since I thought that heat transfer would be more effective using standard CPU thermal compound). A very thin layer of thermal paste was applied on all the middle ("raised") surface of the chip.
Do these temps look normal to you? I just did a basic Debian 0.7.9 SD card install.
Thanks
I just tried my new rockpro64 4GB board and I installed the 30mm tall heatsink to see how it performs (no fan).
After about 5-10 minutes of stress test using sbc-bench.sh -T 80 I found it to reach 75 °C.
At idle it is sitting at about 43 °C (still passively cooling 15 minutes after the end of the stress test)
The heatsink was installed using some NOCTUA NH-H1 thermal compound I had laying around (I didn't use the thermal pad since I thought that heat transfer would be more effective using standard CPU thermal compound). A very thin layer of thermal paste was applied on all the middle ("raised") surface of the chip.
Do these temps look normal to you? I just did a basic Debian 0.7.9 SD card install.
Thanks