I was finally able to work on this Fan's project and I was wondering if someone could tell me if I connected everything in the right way since I have no experience whatsoever in electronics.
https://drive.google.com/open?id=0B3iAYb...JOMmdwYTJF
https://drive.google.com/open?id=0B3iAYb...Y5UmpSWFd3
https://drive.google.com/open?id=0B3iAYb...hRSlRRbWVv
https://drive.google.com/open?id=0B3iAYb...JvQTlhU1Rj
Now my question is... Where do I connect the green cable that is supposed to go to GPIO (Software pwm)? I am thinking to connect it to the gpio89 Pi P5+ bus GPIO2_D1 pin(21) but is already occupied by a jumper wire cable that goes from gpio89 to gpio83.
I am lost to be honest
https://drive.google.com/open?id=0B3iAYb...JOMmdwYTJF
https://drive.google.com/open?id=0B3iAYb...Y5UmpSWFd3
https://drive.google.com/open?id=0B3iAYb...hRSlRRbWVv
https://drive.google.com/open?id=0B3iAYb...JvQTlhU1Rj
Now my question is... Where do I connect the green cable that is supposed to go to GPIO (Software pwm)? I am thinking to connect it to the gpio89 Pi P5+ bus GPIO2_D1 pin(21) but is already occupied by a jumper wire cable that goes from gpio89 to gpio83.
I am lost to be honest