07-14-2018, 06:43 PM
(07-13-2018, 10:47 AM)digitaldaz Wrote: I use odroid.co.uk and get the "32GB eMMC Module C2 Linux "
I tested around with a few of hardkernel's eMMC modules in my Rock64. The board recognized them and was able to read/write to them but I got some errors at some points using the sd2emmc installers to attempt to install a linux distro to the eMMC modules.
I did a bit of a write-up on it over here:
https://archlinuxarm.org/forum/viewtopic...67&t=12706
I haven't really looked into too much what was going on though, but summers over on the Arch Linux ARM forums presented the idea to boot from the sd card with the eMMC module installed and then we would be able to test out the eMMC module from a running system by mounting it and seeing what types of errors occurred, if any.
I will say that it may be dangerous to attempt to 'hot plug' an eMMC module and wouldn't recommend it. I managed to brick an Odroid XU4 by hot-plugging an eMMC module as something in the board got damaged as a result and after performing it I was never again able to get the board to power on or make any attempt to boot.
