05-05-2018, 05:38 AM
As a last resort could use individual connectors along these lines http://www.google.ie/search?q=gpio+cable...5519375744
Could help to isolate the possibility of interference as you can test individual pins in your projects without having all the pins connected on the ribbon cable at the same time.
I assume GPIO is correctly configured at boot time. I do recall a blob file that could be used in the Raspberry Pi board to configure GPIO and a firmware configuration that could be called from sudo raspi-config but I'm not sure how it's handled with the Rock64.
Maybe finding a Distro that handles this might be the answer here.
Could help to isolate the possibility of interference as you can test individual pins in your projects without having all the pins connected on the ribbon cable at the same time.
I assume GPIO is correctly configured at boot time. I do recall a blob file that could be used in the Raspberry Pi board to configure GPIO and a firmware configuration that could be called from sudo raspi-config but I'm not sure how it's handled with the Rock64.
Maybe finding a Distro that handles this might be the answer here.