04-26-2018, 06:22 PM
(04-25-2018, 01:34 AM)larsen8989 Wrote: I use an at to DC in to power my board. now the other day I unplugged my power unit everything was switched off before I did and such. when i plugged it back in my amprage was significantly lower my VSB wire is usually 3A at 5V now it's reading .25A at 5V and the 12V wires are all reading 1A roughly and I was wondering if any one has encountered this problem before.
Sent from my VS995 using Tapatalk
at to DC in?
Do you mean a ATX computer power supply? Amperage being low isn't a problem as that is simply the amount of work being done, but you do have a problem if the voltage (pressure) is low, as it either means the power supply is overloaded (unlikely since you say the amperage is low) or the power supply is faulty (also unlikely if the voltage is low).
If you meant 0.25V on the 5v line, and 1.0V on the 12v line, then it sounds like you need to load up the power supply or instruct it to actually turn on, as ATX power supplies are not meant for light duty loads, or to 'just turn on'.
