Power supply problems.
#1
I use an at to DC in to power my board. now the other day I unplugged my power unit everything was switched off before I did and such. when i plugged it back in my amprage was significantly lower my VSB wire is usually 3A at 5V now it's reading .25A at 5V and the 12V wires are all reading 1A roughly and I was wondering if any one has encountered this problem before.

Sent from my VS995 using Tapatalk
  Reply


Messages In This Thread
Power supply problems. - by larsen8989 - 04-25-2018, 01:34 AM
RE: Power supply problems. - by pfeerick - 04-26-2018, 06:22 PM
Power supply problems. - by larsen8989 - 04-26-2018, 07:58 PM
RE: Power supply problems. - by pfeerick - 04-26-2018, 11:59 PM
Power supply problems. - by larsen8989 - 04-27-2018, 12:32 AM
RE: Power supply problems. - by tllim - 05-03-2018, 09:01 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Which Power Supply Unit for Pine64 A64 DB V1.1 2GB REV B (year 2016)? databaseprogrammer 1 3,597 07-03-2021, 01:29 AM
Last Post: tllim
Lightbulb Alternate Power DC-IN on the Euler Bus also with PI filter for batt operation MarkHaysHarris777 13 27,764 12-19-2020, 09:53 PM
Last Post: evilpete
  Once Again: Power Supply problems I guess (Pine A64+ locking up) marcelser 0 3,804 06-04-2018, 03:11 PM
Last Post: marcelser
  solar power on a Pine64 tablet Little_Johnny 11 18,574 03-20-2018, 12:01 AM
Last Post: pfeerick
  Power up HDDs c4tich 3 7,061 03-18-2017, 09:18 AM
Last Post: Luke
  Provide power in via Pi-2 header BenCranston 22 33,680 03-08-2017, 10:38 PM
Last Post: pfeerick
  any danger from using 2 power sources at same time? dkryder 3 7,770 01-20-2017, 10:45 PM
Last Post: MarkHaysHarris777
Lightbulb A Tale of Two Power Supplies - why good is good and better is best MarkHaysHarris777 9 20,255 01-07-2017, 11:59 PM
Last Post: aegrotatio
  First cable for Euler Bus power done! AVL2016 24 37,232 10-05-2016, 06:43 AM
Last Post: Ghost
  Fuse in the AC power line? cr2016 3 7,574 10-02-2016, 04:35 AM
Last Post: pfeerick

Forum Jump:


Users browsing this thread: 2 Guest(s)