PINE64   ›   PINE A64-LTS / SOPINE Compute Module   ›   Clusterboard   ›   Question on the power resistors

Thread Closed 
Question on the power resistors
bergera
Pine Initiate
**
Joined: Feb 2016
Posts: 12

Reputation: 0
#1
02-15-2018, 08:04 AM
I just got my board yesterday and noticed that it can with two large power resistors. Looking at the schematic they would be R373 and R351. They look to be that they would provide a load to the ATX connector/power supply. Is this correct? I'm in using the the barrel connector so I wouldn't need them? Is there any hard soldering them in place even if I don't use an ATX power supply? It doesn't look like it from the schematic.

Thanks for any in-site I'm hoping to get mine fired up with 2 sopines over lunch.
Thread Closed 


Messages In This Thread
Question on the power resistors - by bergera - 02-15-2018, 08:04 AM
RE: Question on the power resistors - by xalius - 02-15-2018, 08:10 AM
RE: Question on the power resistors - by bergera - 02-15-2018, 08:20 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  sopine socket power problem cgiraldo 1 3,713 06-17-2020, 02:10 PM
Last Post: cgiraldo
  Network problems (actually bad power supply) Unkn0wn 14 20,233 12-01-2019, 10:02 AM
Last Post: venix1
  Supplied Resistors Dreamwalker 5 8,792 09-11-2019, 10:36 AM
Last Post: Dreamwalker
  Power Switch AZClusterboard 1 3,187 02-16-2019, 06:55 AM
Last Post: mdmbc
  Individual SOPINE Power On After Shutdown? Pine 2 4,385 01-30-2019, 08:04 AM
Last Post: mdmbc

Forum Jump:


Users browsing this thread: 1 Guest(s)