|
Power Pine64 via GPIO
|
 (01-25-2016, 11:17 PM)Opine Wrote: Yes, it should be possible, the Euler pin set has DC IN and Battery + connections. I notice that in the pin assignment on the third page they have system LED and reset sw. Does that mean it possible to use the GPI0 to power on the board instead of soldering the tactile switches on? If so, what are the advantages to one over the other? |
| Messages In This Thread |
|
Power Pine64 via GPIO - by dulasu - 01-25-2016, 11:05 PM
RE: Power Pine64 via GPIO - by Opine - 01-25-2016, 11:17 PM
RE: Power Pine64 via GPIO - by 1q84 - 03-14-2016, 10:16 PM
RE: Power Pine64 via GPIO - by tllim - 03-15-2016, 09:22 AM
RE: Power Pine64 via GPIO - by dulasu - 01-26-2016, 01:02 AM
RE: Power Pine64 via GPIO - by Nilocsemliw - 01-26-2016, 11:37 AM
RE: Power Pine64 via GPIO - by Zoidiano0 - 03-15-2016, 05:34 AM
RE: Power Pine64 via GPIO - by HeadShot - 04-01-2016, 09:27 PM
RE: Power Pine64 via GPIO - by Zoidiano0 - 04-01-2016, 09:32 PM
RE: Power Pine64 via GPIO - by Andrew2 - 04-02-2016, 12:18 AM
RE: Power Pine64 via GPIO - by xmasone - 05-06-2016, 04:24 PM
RE: Power Pine64 via GPIO - by HeadShot - 04-02-2016, 09:57 AM
RE: Power Pine64 via GPIO - by Andrew2 - 04-02-2016, 10:36 AM
RE: Power Pine64 via GPIO - by TeaPack - 04-13-2016, 03:36 AM
RE: Power Pine64 via GPIO - by rahlquist - 04-13-2016, 08:22 AM
RE: Power Pine64 via GPIO - by TeaPack - 04-13-2016, 09:43 AM
|
