but do not use the -5V as GND, use the GND from your power supply. otherwise you will get a difference of 10V which will most likely kill the Rock64. After reading this i finally understand your problem from the other thread. maybe you should look deeper into electronics before you solder anything. Damage done by wrong voltage is irreversible most of the times.
|
Secondary power input for Rock64 through pi2 Bus
|
| Messages In This Thread |
|
Secondary power input for Rock64 through pi2 Bus - by nmhart322 - 12-16-2017, 04:45 PM
RE: Secondary power input for Rock64 through pi2 Bus - by xalius - 12-16-2017, 05:07 PM
RE: Secondary power input for Rock64 through pi2 Bus - by mikedhoore - 12-17-2017, 02:42 AM
RE: Secondary power input for Rock64 through pi2 Bus - by dkryder - 12-17-2017, 06:44 AM
RE: Secondary power input for Rock64 through pi2 Bus - by nmhart322 - 12-17-2017, 04:58 PM
RE: Secondary power input for Rock64 through pi2 Bus - by xalius - 12-17-2017, 08:41 AM
RE: Secondary power input for Rock64 through pi2 Bus - by Lamensis - 12-18-2017, 01:56 AM
|
Users browsing this thread: 1 Guest(s)

