10-11-2017, 01:02 AM
(10-06-2017, 05:05 AM)dkryder Wrote: the part about being able to use that info for pinout data i would think is ok. by that i mean lacking any other sources of info i have used that datasheet. but even then in baby steps at a time. i have some hardware data pin extenders for that cable because at one time i wanted to try and swap over some of those lines to fit another panel. and i started with the power cause without it you can do little else and if i'm wrong then the experiment ends right there. you can check continuity with a multi-meter. if you have a scope or dc power supply then at lower voltages that may not damage the hardware. anyway, if tllim put up the datasheet then i would hope the pinout is correct. i did not do any damage to my stuff. however, i had to put the project on the back burner and have not started up yet.
There is no LCD model or vendor changed and the datasheet was released from vendor.