JTAG interface?

[tllim]

I am not asking for a connector (that would cost money)

what I am asking for is this:

• At least Solderable pads that support JTAG
  
• Make sure JTAG is enabled (some SoC companies blow fuses to disable JTAG)
  
• Access to sufficent docs that are the chip specific JTAG (i.e.: Chain geometry, etc) 
  

Will this be available?

---

NOTE: I also see there are two JTAG-SEL pins, These need to be "modifiable" by some means.

Option 1: A sufficient solution would be trace on the PCB that can be cut with a razor knife (this would be zero cost) please make these large enough that a human can actually do this.

Option 2: Would be to use some zero-ohm components that can be removed or changed

Also will need documentation about what these pins do, etc - they are not well documented in the existing PDFs on the Pine64 web site (the documents say the pins exist, but do not say what the pins do)

-Duane.

Noted on your request. Unfortunately we didn't bring out the solder pad. If you interest to dig further, there is Allwinner SoC data sheet on the Pine64 wiki page (http://wiki.pine64.org).